@erichogan9769
wish i had seen a video like this when I was installing mine
@ikpalian4413
Wow! I really love ur video but my question is, is This type of access control module an automatic control because you didn't perform any kind of configuration
@joshbeasley21
Your maglock is on the unsecure side of the door. Also no anchor or retro box was used, I could easily take the reader off the wall, short the power wires together and everything on that circuit will now have no power, not to mention that reader port on the controller is now fried.
@steveche42
We just took over a space that has this system already wired. Is there a way we can use this system? How do i get new access cards?
@Ernesto-p4o
Don’t ever rely on you panel or software to unlock you door with a REX button, ALWAYS wire the REX button in series with your lock!
@statracing1
We currently have a Linear 212SE, can we use that is conjunction with this unit so we can change pin codes remotely?
@peterwilson4871
With you mag lock install you forgot to install the locating pins on the armature it is also to low to get a seal on a monitored mag lock
@michaelknight2897
Is it possible to wire in a switch (lock/unlock) to the mercury board? The door is on a schedule, but the office person wants to lock it when they are out of the office and doesn't want to manual locks.
@aduemmanuel1284
Good job
@samaadkhan
Amazing bro
@-ProSystem
This reader can be changed to a Barcode Scanner .. ?!
@paulm4745
if i wanted to wire an automatic gate to the system, would i use just and 18/2 from control panel to automatic gate panel? If so, where on automatic gate panel would i wire it to? thanks
@RacelifeCo
What happens in the event of a power failure? Does your door unlock if there's no power to the building?
@GrenPara
Pretty Good video. Thou did not cover type of Reader wire, gauge, shielded or non-shielded , twisted pair or regular. Do not be lazy! wires should be soldered and then heat shrinked and then taped to prevent damage from running new lines or removal.
@steve7680
Does the Linear have a place for the Red and Green LEDs from the Card Reader? (Brown and Orange wires)
@jeromeswaby5261
Hello there I need some help I have the same power supply and mag lock that's in the video I'm installation it on my gate the drive way is about 100 feet long from the house when ever I try to ring the door bell from the gate it doesn't ring and the mag locking force is weak the wire am using is CAT 5 and the power supply is in the living 5AMP power supply am using!
@chrisp1850
I'm running into issues where my circuit boards are no longer powering up. This happened after a failed battery backup.
@maximumwoof8662
those blue things are called "wire nuts"
@emmannew6740
Can you connect access to auto ops?
@robertmcgehee949