@vicpetrishak7705

Midtronics manufacturers a handheld battery 
diagnostics tester that also checks starter and alternator condition . If there is a fresh charge to the battery , turn headlamps on for 2 minutes to remove the surface charge from the battery .

@bortz0230

1 volt difference between the two batteries under load and you're ready to chuck the one that pulls to 9v compared to 10v? You can desulfate the lower voltage one and bring it back to life for a minimum of 10v pull, with a simple overcharge on a dc power supply (see youtube videos on desulfating lead-acid batteries). Don't throw in the towel yet my man. Even in the weakened condition, that lower cca battery can still get you through a warm climate summer even without desulfating it on a charger. I've gotten 10+ years on some batteries by tuning them up that way. Great video.

@404notfound.....

I see the midtronics pbt 300 on the battery cart. Good choice 👌

@arthurlewis605

Who sells Ferret test equipment?

@sahidsk1013

Should i increase the load more than half of the cold cranking amp or not. If yes then what will be the procedure. 
Please reply

@nickv4073

So how is this different than a $15 Harbor Freight battery load tester? It works just as well at determining the health of a car battery.

@buckmajor

Hi, is this the same test for a scooter battery? I charged my battery and the multimeter reading is 14volts but I still can't start the scooter?

@arthurlewis605

Who sells Ferret test equipment?