@MrCareer707

Thank you for this video, I am encountering issues though, to compile this sketch I am using an ESP32 WROVER Module Cheap Yellow Display_, but it always comes up with errors, I installed the ESP32 WROVER Module with v2.0.7 and only 1 error caused the failure to compile, so I am assuming that Board Version is a deciding factor in successful Compilation, I am new to Arduino IDE, Relatively new to C Programming (I used C quite extensively in my late teens and most of my 20's) that was over 2 decades ago, Is the Board version critical for Compilation to succeed and if so how best would one be to determining which board version to use?

Thank you